How To Measure Ring Size Inches? (Solution found)

INSTRUCTIONS FOR MEASURING:

  1. Make a string that is approximately 6 inches in length. Fold the thread around the base of each finger, right below the knuckle. With the pen, mark the spot where the string comes to an end. Place the measured string on the ruler so that the area marked on your right is covered.

How can I measure my ring size in inches at home?

HOW TO MEASURE THE SIZE OF YOUR RING IN INCHES AT HOUSE

  1. Make a thin strip of paper out of it. Wrap the paper around your index and middle fingers. Please make sure that the paper is positioned below the joint of your finger and near your knuckle. Using your ruler, mark the point where the two sheets of paper come together and measure the distance. To find out what size ring you need, use the table below.

How do I measure my ring size without a Sizer?

Wrap a thread or a piece of paper around the base of your index and middle fingers. Make a mark with a pen at the spot where the two ends come together. Using a ruler, measure the length of the thread or paper (mm). To determine your ring size, find the measurement that is the closest to your finger size on the ring size chart.

How can I find out my ring size online?

Begin by wrapping the tool around the broadest area of your finger, starting with the flat end (which is the knuckle). Continue to wrap the tool around your finger until it is securely in place. Take note of where the arrow’s tip is pointing. Your ring size is determined by the number that is closest to the arrow point.

You might be interested:  Which Hand Does Promise Ring Go On? (Solution found)

Can I measure my ring size with a tape measure?

When it comes to determining your ring size, a measuring tape is the most exact and reliable way. It is also possible that the same finger on your left and right hands will have different ring sizes; thus, make sure you measure the finger on which you intend to wear the ring.

Leave a Reply

Your email address will not be published. Required fields are marked *