Follow these methods to determine your ring size:
- String or paper should be wrapped around the base of your finger. A pen should be used to indicate where the two ends meet. Using a ruler (mm), measure the length of the thread or paper. To determine your ring size, choose the measurement that is closest to your finger size on the ring size chart.
How do you figure out your ring size without measuring it?
Instead of a measuring tape, you can measure her ring size using a piece of string or dental floss and a ruler or carpenter’s tape measure at home, if you do not have one. Simply wrap the string or floss around the thickest portion of her ring finger and cut or mark the string at the appropriate point on the finger. Then, using a ruler or tape measure, take the measurement.
Is there an app to measure ring size?
Instead of using measuring tape, you can measure her ring size using a piece of string or dental floss and a ruler or carpenter’s tape measure at home, if you do not have any. Simply wrap the string or floss around the thickest portion of her ring finger and cut or mark the string at the appropriate point on her finger. Take a ruler or tape measure and mark the distance.
How do you measure your fingers for rings?
Create an imaginary ring finger by wrapping a thread or piece of paper around the finger that will be used for the ring. The place where the thread or piece of paper overlaps should be marked, and the length of that string or piece of paper should be measured, either in millimeters or inches, after that. After that, you may use a conversion table to figure out what size you are.
What is the most common ring size for a woman?
The average ring size for a woman is 6, while the average ring size for a man is 812. The ability to accurately estimate your partner’s ring size may be achieved with a little common sense. Because a tiny partner’s hands are likely to be smaller with slim fingers, start with a size 4 or 412 for women and a size 7 for men if you have a diminutive spouse.
How can I measure my ring size without a ruler?
Step 1: Cut a thin (but lengthy) strip of paper from the sheet of paper. In step two, wrap a piece of paper around your ring finger just below the knuckle (you’ll want to make sure your ring can easily fit over this section). Using the thin strip of paper, flatten it down and measure the distance between the mark you just created and the end of the paper you used.